《电子技术应用》
您所在的位置:首页 > 模拟设计 > 解决方案 > TIADS529480MSPS8路医学图像解决方案

TIADS529480MSPS8路医学图像解决方案

2011-11-23
作者:TI公司

TI公司的ADS5294是80MSPS/14位 8路ADC,具有低功耗,高SNR和低SFDR,以及连续过载恢复,适用于高性能系统设计. ADS5294具有数乁信号处理核,包括数字滤波器模块, 可编程数字增益0 dB到12 dB,内部和外接基准电压,1.8V工作电压,主要用在超声图像,通信设备和多路数据采集.本文介绍了ADS5294主要特性,方框图, 模拟输入模型和电路,评估模块测试图以及评估模块电路图,材料清单和PCB布局图.

Using CMOS process technology and innovative circuit techniques, the ADS5294 is a low power 80MSPS 8-Channel ADC. Low power consumption, high SNR, low SFDR, and consistent overload recovery allow users to design high performance systems.

The ADS5294 has a digital processing block that integrates several commonly used digital functions for improving system performance. It includes a digital filter module that has built-in decimation filters (with low-pass, high-pass and band-pass characteristics).

The decimation rate is also programmable (by 2, by , or by 8). This makes it useful for narrow-band applications, where the filters can be used conveniently to improve SNR and knock-off harmonics, while at the same time reducing the output data rate. The device includes an averaging mode where two channels (or even four channels) can be averaged to improve SNR.

Serial LVDS outputs reduce the number of interface lines and enable the highest system integration. The digital data from each channel ADC can be output over one or two wires of LVDS output lines depending on the ADC sampling rate. This 2-wire interface helps keep the serial data rate low, allowing low cost FPGA based receivers to be used even at high sample rate. The ADC resolution can be programmed to 12 bit or 14 bit through register. A very unique feature is the programmable mapping module that allows flexible mapping between the input channels and the LVDS output pins. This helps greatly reduce the complexity of LVDS output routing and can potentially result in cheaper system boards by reducing the number of PCB layers.

The device integrates an internal reference trimmed to accurately match across devices. Best performance is expected to be achieved through the internal reference mode. The device can be driven with external references as well. The device is available in a 12 mm × 12 mm 80-pin QFP. It is specified over a –40°C to 85°C operating temperature range. ADS5294 is completely pin-to-pin and register compatible to ADS5292 QFP. It is specified over a –40°C to 85°C operating temperature range. ADS5294 is completely pin-to-pin and register compatible to ADS5292.

ADS5294主要特性:

Maximum Sample Rate: 80 MSPS/14-Bit

High Signal-to-Noise Ratio

75.5-dBFS SNR at 5 MHz/80 MSPS

78.2-dBFS SNR at 5 MHz/80 MSPS and Decimation Filter Enabled

84-dBc SFDR at 5 MHz/80 MSPS

Low Power Consumption

58 mW/CH at 50 MSPS

77 mW/CH at 80 MSPS (2 LVDS Wire Per Channel)

Digital Processing Block

Programmable FIR Decimation Filter and Oversampling to

Minimize Harmonic Interference

Programmable IIR High Pass Filter to Minimize DC Offset

Programmable Digital Gain: 0 dB to 12 dB

2- or 4- Channel Averaging

Flexible Serialized LVDS Outputs:

One or Two Wires of LVDS Output Lines per Channel

Depending on ADC Sampling Rate

Programmable Mapping Between ADC Input Channels and

LVDS Output Pins-Eases Board Design

Variety of Test Patterns to Verify Data Capture

by FPGA/Receiver

Internal and External References

1.8V Operation for Low Power Consumption

Low-Frequency Noise Suppression

ADS5294应用:

Ultrasound Imaging

Communication Applications

Multi-channel Data Acquisition

图1. ADS5294方框图

图2. ADS5294模拟输入模型

图3. ADS5294模拟输入驱动电路

ADS5294评估模块

This user’s guide gives a general overview of the evaluation module (EVM) and provides a general description of the features and functions to be considered while using this module. This manual is applicable to the ADS5294 analog-to-digital converters (ADC), which collectively are referred to as ADS529x. Use this document in combination with the respective ADC data sheet. The ADS529xEVM provides a platform for evaluating the ADC under various signal, clock, reference, and power supply conditions.


图4.ADS5294 EVM和TSW1250EVM硬件连接图

图5.ADS5294评估测试图

图6.ADS5294 EVM电路图(1)

图7.ADS5294 EVM电路图(2)

图8.ADS5294 EVM电路图(3)

图9.ADS5294 EVM电路图(4)

图10.ADS5294 EVM电路图(5)

图11.ADS5294 EVM电路图(6)

图12.ADS5294 EVM电路图(7)

图13.ADS5294 EVM电路图(8)

图14.ADS5294 EVM电路图(9)

ADS5294 EVM材料清单(BOM):



图15.ADS5294 EVM PCB布局图
详情请见:
http://www.ti.com/lit/ds/symlink/ads5294.pdf

http://www.ti.com/lit/ug/slau355/slau355.pdf



本站内容除特别声明的原创文章之外,转载内容只为传递更多信息,并不代表本网站赞同其观点。转载的所有的文章、图片、音/视频文件等资料的版权归版权所有权人所有。本站采用的非本站原创文章及图片等内容无法一一联系确认版权者。如涉及作品内容、版权和其它问题,请及时通过电子邮件或电话通知我们,以便迅速采取适当措施,避免给双方造成不必要的经济损失。联系电话:010-82306118;邮箱:aet@chinaaet.com。