《电子技术应用》
您所在的位置:首页 > 模拟设计 > 解决方案 > ADIAD9739AFMC卡和XilinxSP605参考设计方案

ADIAD9739AFMC卡和XilinxSP605参考设计方案

2012-08-01

ADI公司的AD9739A FMC卡是Xilinx SP605, ML605或KC705评估板的子板.两者组成的平台能把MPEG TS流转换成IF或RF信号(单路或多路),并支持大多数数字电视标准(DVB-C,J.83B, DVB-T, ATSC, DVB-S, ...),并可用来评估多种IP核如DVB-C J.83 Annex A/C 调制器,J.83 B有线调制器,DVB-T/H调制器, ATSC调制器,DVB-S调制器等. 主要用在MVD IP核(TS处理,调制,RF上变换).本文介绍了AD9737A/AD9739A产品亮点和主要特性,功能框图以及ADI AD9739A FMC卡+ Xilinx SP605评估平台框图,主要特性和ADI AD9739A FMC评估板电路图.

The AD9737A/AD9739A are 11-bit and 14-bit, 2.5 GSPS high performance RF DACs that are capable of synthesizing wideband signals from dc up to 3 GHz. The AD9737A/AD9739A are pin and functionally compatible with the AD9739 with the exception that the AD9737A/AD9739A do not support synchronization or RZ mode, and are specified to operate between 1.6 GSPS and 2.5 GSPS.

By elimination of the synchronization circuitry, some nonideal artifacts such as images and discrete clock spurs remain stationary on the AD9737A/AD9739A between power-up cycles, thus allowing for possible system calibration. AC linearity and noise performance remain the same between the AD9739 and the AD9737A/AD9739A.

The inclusion of on-chip controllers simplifies system integration. A dual-port, source synchronous, LVDS interface simplifies the digital interface with existing FGPA/ASIC technology. On-chip controllers are used to manage external and internal clock domain variations over temperature to ensure reliable data transfer from the host to the DAC core. A serial peripheral interface (SPI) is used for device configuration as well as readback of status registers.

The AD9737A/AD9739A are manufactured on a 0.18 μm CMOS process and operate from 1.8 V and 3.3 V supplies. They are supplied in a 160-ball chip scale ball grid array for reduced package parasitics.

AD9737A/AD9739A产品亮点:

1. Ability to synthesize high quality wideband signals with bandwidths of up to 1.25 GHz in the first or second Nyquist zone.

2. A proprietary quad-switch DAC architecture provides exceptional ac linearity performance while enabling mix-mode operation.

3. A dual-port, double data rate, LVDS interface supports the maximum conversion rate of 2500 MSPS.

4. On-chip controllers manage external and internal clock domain skews.

5. Programmable differential current output with an 8.66 mA to 31.66 mA range.

AD9737A/AD9739A主要特性:

Direct RF synthesis at 2.5 GSPS update rate

DC to 1.25 GHz in baseband mode

1.25 GHz to 3.0 GHz in mix-mode

Industry leading single/multicarrier IF or RF synthesis

Dual-port LVDS data interface

Up to 1.25 GSPS operation

Source synchronous DDR clocking

Pin compatible with the AD9739

Programmable output current: 8.7 mA to 31.7 mA

Low power: 1.1 W at 2.5 GSPS

AD9737A/AD9739A 应用:

Broadband communications systems

DOCSIS CMTS systems

Military jammers

Instrumentation, automatic test equipment

Radar, avionics

图1.AD9737A/AD9739A功能框图

The AD9739A is a 14-bit, 2.5 GSPS high performance RF DAC capable of synthesizing wideband signals with up to 1.25GHz of bandwidth. This reference design includes a single tone sine generator (DDS) and allows programming the device and monitoring it’s internal status registers. It also programs the ADF4350 clock chip which can generate a 1.6GHz to 2.5GHz clock for the AD9739A from the on-board 25MHz crystal. An alternate clock path using an ADCLK914 is available for driving the clock externally.

图2.AD9739A FMC评估板外形图

Eval Board w/ an FMC connector for Xilinx based FPGA development

The Analog Devices AD9739A FMC card is a daughter board that can be used in addition to Xilinx SP605, ML605 or KC705 evaluation boards.

The resulting platform includes all necessary components for the evaluation of most of our IP cores.           
图3.ADI AD9739A FMC卡+ Xilinx SP605评估平台框图

                    
                    

图4.ADI AD9739A FMC卡+ Xilinx SP605评估平台外形图

ADI AD9739A FMC卡+ Xilinx SP605评估平台主要特性:

The evaluation platform converts an MPEG TS stream into an IF or RF signal (single or multi-channel) and supports most of the digital TV standards (DVB-C, J.83B, DVB-T, ATSC, DVB-S, ...).

The evaluation platform can be used for the evaluation of our IP cores:

DVB-C J.83 Annex A/C modulator

J.83 B cable modulator

DVB-T/H modulator

ATSC modulator

DVB-S modulator

Digital RF Up Converter

DVB Remultiplexer N-to-M

Hardware UDP/IP stack

RTP transmitter

Inputs/Ouputs

1 x UDP/IP input/output for MPEG TS input and IP cores registers configuration

(RJ45 connector on Xilinx SP605/ML605/KC705 board)

1 x IF/RF output (SMA connector on Digilent board)

Typical applications

Evaluation of MVD Cores’ IP cores (TS processing, Modulation, RF Up conversion)

图5.AD9739A FMC评估板电路图(1)

图6.AD9739A FMC评估板电路图(2)

图7.AD9739A FMC评估板电路图(3)

图8.AD9739A FMC评估板电路图(4)

图9.AD9739A FMC评估板电路图(5)
详情请见:
http://www.analog.com/static/imported-files/data_sheets/AD9737A_9739A.pdf

http://wiki.analog.com/_media/resources/fpga/xilinx/fmc/ad9739a-fmc-ebz_revb_schematic.pdf



本站内容除特别声明的原创文章之外,转载内容只为传递更多信息,并不代表本网站赞同其观点。转载的所有的文章、图片、音/视频文件等资料的版权归版权所有权人所有。本站采用的非本站原创文章及图片等内容无法一一联系确认版权者。如涉及作品内容、版权和其它问题,请及时通过电子邮件或电话通知我们,以便迅速采取适当措施,避免给双方造成不必要的经济损失。联系电话:010-82306118;邮箱:aet@chinaaet.com。